Band and Hinge Assembly
Band Springs
Big Green Egg Base
Big Green Egg Dome
Big Green Egg Fire Box
Big Green Egg Fire Ring
Ceramic Damper Top
Fire Grate
Handle Replacement Kit
Hardware pack for Band
Hardware pack for Nest
High-Performance Gasket Kits
- Gasket Replacement Kit for 2XL (requires 2), XL and Large EGG – 113726
- Gasket Replacement Kit for Medium, Small, MiniMax and Small EGG – 113733
Locking Caster Kit (2 in)
Locking Caster Kit (4 in)
- Heavy-duty for better wear through high-use conditions
- 2-way brake locks both roll and rotation
- Solid polyurethane wheel
Mesh Screen for a Stainless Steel Draft Door
rEGGulator Vent Cap
- Precise temperature control at your fingertips
- Made of durable cast iron with a proprietary super pre-seasoned finish for greater weather resistance
- Silicone adjustment tab is cool to the touch throughout cook
- Completely shuts off EGG when fully closed
- Designed for permanent placement on the EGG dome; does not need to be removed after cooking
- Designed for all weather use; keeps rain out when not in use –eliminating the need for a ceramic damper top
- Fully open vent allows 50% greater airflow than the traditional Dual Function Metal Top
- Mating surface is designed to minimize ‘sticking’ when cold
- Designed to work with the optional Rain Cap
Replacement Grid
Temperature Gauge, 2 inch Dial
- 750F° / 400C°
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212°F/100°C at sea level. Boiling point decreases approx 2° with each 1000’ of altitude. If the thermometer does not read 212°F/100°C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION – Do not adjust hot thermometer with bare hands!
- CAUTION – Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION – Thermometer tip is sharp, do not leave unattended or place within reach of children.
Temperature Gauge, 3 inch Dial
- 750F° / 400C°
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212°F/100°C at sea level. Boiling point decreases approx 2° with each 1000’ of altitude. If the thermometer does not read 212°F/100°C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION – Do not adjust hot thermometer with bare hands!
- CAUTION – Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION – Thermometer tip is sharp, do not leave unattended or place within reach of children.